Table of Contents
Advertisement
2. For Indoor/outdoor models, loosen screws
along the fireplace top face. Remove two
screws along fireplace face side. Slide
hood underneath screws on top and
tighten screws. Replace screws on side
of fireplace face side securing hood to the
face (see Figure 13).
Hood
Remove/Replace
Side Screws
Figure 13 - Hood Placement
(Model May Vary From Illustration)
Note: Use only original replacement parts.
This will protect your warranty coverage for
parts replaced under warranty.
Contact authorized dealers of this product. If
they can't supply original replacement part(s),
call INNOVATIVE HEARTH PRODUCTS at
1-800-655-2008.
You may have further questions about instal-
lation, operation, or troubleshooting. If so,
contact INNOVATIVE HEARTH PRODUCTS
at 1-800-655-2008. When calling please have
your model and serial numbers of your heater
ready.
14
INSTALLATION
Continued
Loosen Top
Screws
REPLACEMENT PARTS
TECHNICAL SERVICE
www.SuperiorFireplaces.US.com
3. Insert each screen rod through all rings
located at top of screen.
4. Insert first rod into rear hole in left side of
firebox. Fasten rod to rear hole near center
of firebox using #10 x 3/8" Phillips screw
provided (see Figure 14).
5. Insert other rod into front hole on right
side of firebox and fasten using remaining
Phillips screw.
Top View of Rod Layout
Rear Hole
Front Hole
Rod
Ring
Screen
Figure 14 - Installing Fireplace Screen
(Model May Vary From Illustration)
When calling, have ready:
• your name
• your address
• model and serial numbers of your heater
• how heater was malfunctioning
• purchase date
Usually, we will ask you to return the part to
the factory.
You can also visit our web site at
www.IHP.US.com.
Identification
Label
Location
Screw
127032-01A
Advertisement
Table of Contents
