Table of Contents
Advertisement
Service Manual
Model No.:
Note (1) No connection: These PINS are used only for the product of SAMSUNG.
(DO NOT CONNECT the input device to these pins.)
Note (2) Pin No. 1, 2, 3 are used only for I2C communication in flicker tuning.
(Refer to 9.5 Process Executing Guide)
Note (3) If set input is 8bit LVDS signal, Keep Echannel level 0
Pin No.24 / Pin No.40 : Pull up(3.3V) with 1.5kohm resistor.
Pin No.25 / Pin No.41 : Pull down(GND) with 1.5kohm resistor.
Note (4) Pin number which starts from the left side.
Fig . The diagram of connector
b. All power input pins should be connected together.
c. All NC pins should be separated from other signal or power.
Hide quick links:
Advertisement
Table of Contents
