Advertisement
3.1.4 Removing the heat sink
(See Fig.4)
• Prior to performing the following procedure, remove the front
panel assembly as required.
(1) Remove the two screws B and screw C on the left side of
the main body.
3.1.5 Removing the rear bracket
(See Fig.5)
• Prior to performing the following procedures, remove the bot-
tom cover.
(1) Remove the three screws D, three screws E and two
screws F on the back side of the main body.
(2) Remove the rear bracket.
3.1.6 Removing the main board
(See Fig.6)
• Prior to performing the following procedures, remove the front
panel assembly, bottom cover, front chassis assembly, heat
sink and rear bracket.
(1) Remove the two screws G attaching the main board.
(2) Disconnect the connector
board.
CN501
and remove the main
C
Fig.4
E
Rear bracket
D
Fig.5
Main board
G
CN501
Fig.6
B
Heat sink
F
F
E
D
G
(No.49871)1-7
Advertisement
