Table of Contents
Advertisement
Getting started
Handset battery installation
Install the battery as shown below.
1.
Plug the battery connector securely
into the socket inside the handset
battery compartment, matching the
orientation of the engraved label.
3.
Align the cover flat against the
battery compartment, then slide it
towards the center of the handset
until it clicks into place.
•
If the handset will not be used for a long time, disconnect and remove the battery to
prevent possible leakage.
•
To purchase replacement batteries, visit our website at www.vtechcanada.com or
call 1 (800) 267-7377.
IMPORTANT:
Check for a dial tone by pressing
If you do not hear a dial tone:
•
Make sure the installation procedures described above are properly done.
•
It may be a wiring problem. If you have changed your telephone service to digital service from
a cable company or a VoIP service provider, the telephone line may need to be rewired to
allow all existing telephone jacks to work. Contact your cable/VoIP service provider for more
information.
2.
Place the battery with the label
THIS SIDE UP facing up and the wires
inside the battery compartment.
4.
Place the handset in the handset
charger to charge. The CHARGE light
is on when the handset is charging.
/HOME. If you hear a dial tone, the installation is successful.
3
CHARGE light
remains on when
charging.
Advertisement
Table of Contents
