Behringer Ultra Tremolo PAN TP300 Manual

ULTRA TREMOLO/PAN TP300
Thank you for showing your confidence in us by purchasing the BEHRINGER ULTRA TREMOLO/PAN
TP300. This high-quality effects pedal is designed to provide guitarists easy-to-use tremolo and panning
effect styles. Thanks to its high-performance features you get the classic, warm and mind-bending tremolo/
panning effects of vintage '60s amps.
The tremolo effect is achieved by periodic modulation of the input signal level. This results in a continuous
change from low to high level that has a quivering, tremulous sound character. In panning mode the signal
is periodically moved from one side of stereo image to the other.
The MODE switch selects between 2 tremolo modes and 2 panning modes.
{1}
PAN: Signal fluctuates between the left and right side of the stereo image. For this effect both outputs
(stereo) have to be used. In Triangle Wave mode the signal fluctuates smoothly while in Square mode
it changes sharply.
TREMOLO: Periodic changes of the signal level. In Triangle Wave mode the signal level fluctuates
smoothly while in Square mode it changes sharply.
{2} The DEPTH control adjusts the amount of fluctuation concerning the signal level (TREMOLO) and
signal position (PAN).
{3} The RATE control adjusts the speed of the fluctuation concerning the signal level (TREMOLO) and
signal position (PAN).
The RATE LED displays the speed of the effect determined with the RATE control (flashes).
{4}
The ON/BATT LED illuminates when the effect is activated. It also serves as a battery level indica-
{5}
tor.
Use the footswitch to activate/deactivate the effect.
{6}
Use the 1/4" TS IN A and IN B connectors to plug in the instrument cables. For mono use plug in IN
{7}
A only.
The two 1/4" TS OUT A and OUT B connectors send the signal to your amp. Use both connectors if
{8}
you want to achieve full stereo effect. For mono use plug in OUT A only.
Use the DC IN connection to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or replace the 9 V battery
(not included), press the hinges with a ballpoint pen and remove the pedal cover. Be careful not to scratch
the unit.
The TP300 has no on/off switch. As soon as you insert the plug into the in connector, the
+
TP300 is on. When not in use, remove the plug from the in connector. This extends the life of
the battery.
The SERIAL NUMBER is located at the underside.
For our current warranty terms, please refer to our website at http://www.behringer.com.
1. CONTROLS
Top view
2. WARRANTY
A50-51213-00003