Advertisement
Limitations: Implied warranties, including those of fitness for a particular purpose and merchantability (an unwritten warranty that the
Product is fit for ordinary use) are limited to one year from the date of purchase. Some states/provinces do not allow limitations on how long
an implied warranty lasts, so the above limitation may not apply to you. In no event shall VTech be liable for any indirect, special, incidental,
consequential, or similar damages (including, but not limited to lost profits or revenue, inability to use the Product or other associated
equipment, the cost of substitute equipment, and claims by third parties) resulting from the use of this Product. Some states/provinces do
not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you.
Please retain your original sales receipt as proof of purchase.
FCC, ACTA and IC regulations
FCC Part 15
This equipment has been tested and found to comply with the requirements for a Class B digital device under Part 5 of the Federal
Communications Commission (FCC) rules. These requirements are intended to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this equipment not expressly approved by the party responsible for compliance could void the user's authority
to operate the equipment.
This device complies with Part 5 of the FCC rules. Operation is subject to the following two conditions: () this device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation. Privacy of communications may not be ensured when using this telephone.
To ensure safety of users, the FCC has established criteria for the amount of radio frequency energy that can be safely absorbed by
a user or bystander according to the intended usage of the product. This product has been tested and found to comply with the FCC
criteria. The handset may be safely held against the ear of the user. The telephone base shall be installed and used such that parts of the
user's body other than the hands are maintained at a distance of approximately 20 cm (8 inches) or more.
This Class B digital apparatus complies with Canadian ICES-003.
FCC Part 68 and ACTA
This equipment complies with Part 68 of the FCC rules and with technical requirements adopted by the Administrative Council for
Terminal Attachments (ACTA). The label on the back or bottom of this equipment contains, among other things, a product identifier in the
format US:AAAEQ##TXXXX. This identifier must be provided to your telephone service provider upon request.
The plug and jack used to connect this equipment to premises wiring and the telephone network must comply with applicable Part 68
rules and technical requirements adopted by ACTA. A compliant telephone cord and modular plug is provided with this product. It is
designed to be connected to a compatible modular jack that is also compliant. An RJ jack should normally be used for connecting to a
single line and an RJ4 jack for two lines. See the installation instructions in the user's manual.
The Ringer Equivalence Number (REN) is used to determine how many devices you may connect to your telephone line and still have
them ring when you are called. The REN for this product is encoded as the 6th and 7th characters following the US: in the product
identifier (e.g., if ## is 03, the REN is 0.3). In most, but not all areas, the sum of all RENs should be five (5.0) or less. For more
information, please contact your telephone service provider.
This equipment may not be used with Party Lines. If you have specially wired alarm dialing equipment connected to your telephone line,
ensure the connection of this equipment does not disable your alarm equipment. If you have questions about what will disable alarm
equipment, consult your telephone service provider or a qualified installer.
If this equipment is malfunctioning, it must be unplugged from the modular jack until the problem has been corrected. Repairs to this
telephone equipment can only be made by the manufacturer or its authorized agents. For repair procedures, follow the instructions
outlined under the Limited warranty.
If this equipment is causing harm to the telephone network, the telephone service provider may temporarily discontinue your telephone
service. The telephone service provider is required to notify you before interrupting service. If advance notice is not practical, you will be
notified as soon as possible. You will be given the opportunity to correct the problem and the telephone service provider is required to
inform you of your right to file a complaint with the FCC. Your telephone service provider may make changes in its facilities, equipment,
operation, or procedures that could affect the proper functioning of this product. The telephone service provider is required to notify you if
such changes are planned.
If this product is equipped with a corded or cordless handset, it is hearing aid compatible.
If this product has memory dialing locations, you may choose to store emergency telephone numbers (e.g., police, fire, medical) in these
locations. If you do store or test emergency numbers, please:
Remain on the line and briefly explain the reason for the call before hanging up.
Perform such activities in off-peak hours, such as early morning or late evening.
Industry Canada
Operation is subject to the following two conditions: () this device may not cause harmful interference, and (2) this device must accept
any interference, including interference that may cause undesired operation.
The term ''IC:'' before the certification/registration number only signifies that the Industry Canada technical specifications were met.
The Ringer Equivalence Number (REN) for this terminal equipment is .0. The REN is an indication of the maximum number of devices
allowed to be connected to a telephone interface. The termination on an interface may consist of any combination of devices subject only
to the requirement that the sum of the RENs of all the devices does not exceed five.
This product meets the applicable Industry Canada technical specifications.
Technical specifications
Frequency control
Transmit frequency
Channels
Nominal effective range
Power requirements
Memory
VTECH TELECOMMUNICATIONS LTD.
A member of THE VTECH GROUP OF COMPANIES.
Distributed in the U.S.A. by VTech Communications, Inc., Beaverton, Oregon 97008.
Distributed in Canada by VTech Technologies Canada Ltd., Richmond, B.C. V6W L5.
VTech is the registered trademark of VTech Holdings Limited.
Copyright © 203 for VTECH TELECOMMUNICATIONS LTD.
All rights reserved. Printed in China.
Crystal controlled PLL synthesizer
Handset: 92.536-928.448 MHz
Telephone base: 92.536-928.448 MHz
5
Maximum power allowed by FCC and IC. Actual operating range may vary according to
environmental conditions at the time of use.
Handset: 2.4V Ni-MH battery
Telephone base: 6V DC @ 400mA
Charger: 6V AC @ 300mA
Directory: 50 memory locations; up to 30 digits and 5 characters
Caller ID log: 50 memory locations; up to 24 digits and 5 characters
2
9-00778-030-00
Advertisement
