Settings; Controlling The Sound Bar With Tv Remote Control (Tv Remote Control Learning Function) - Yamaha ATS-1520 Owner's Manual

Settings

Controlling the sound bar with TV remote control
(TV remote control learning function)
You can use the TV remote control to turn on/off the sound bar or adjust its volume by
having the sound bar learn the TV remote control signals.
NOTE
• This function is available only when your TV remote control uses infrared signals.
• Depending on the installation conditions or settings of the sound bar, both the sound bar and TV will
receive the TV remote control signals and operate simultaneously.
1
Turn off the TV and sound bar.
2
Hold down the LEARN key on the supplied remote control for more
than 3 seconds to set the sound bar to the learning mode.
When the sound bar is in the learning mode, the indicators on the front panel flash
as shown below.
NOTE
• Steps 3 to 6 require only the TV remote control and the keys on the front panel of the sound bar. The
remote control of the sound bar is not necessary.
3
Make the sound bar learn the mute operation.
3-1 Press INPUT on the front panel of the sound bar.
3-2 While pointing your TV remote control at the remote control sensor, hold
down the mute key for more than 1 second twice or three times.
Approx. 30 cm (1 ft)
TV remote control
Hold down Release
(more than 1 second) (more than 1 second)
Result Bleep/buzzer
Successfully
Once
learned
Learning has
failed
Twice
* Repeat from
Step 3-1.
4
Make the sound bar learn the volume (–) operation.
4-1 Press VOLUME (–) on the front panel of the sound bar.
4-2 While pointing your TV remote control at the remote control sensor, hold
down the volume (–) key for more than 1 second twice or three times.
Result Bleep/buzzer
Successfully
Once
learned
Learning has
failed
Twice
* Repeat from
Step 4-1.
Hold down Release
(more than 1 second) (more than 1 second)
Indicators
Lights up
Flash
Indicators
Lights up
Flash
Continued
➜
En 11