Download Print this page

Alpine RUE-4136 Owner's Manual

Remote controller for dvd navigation system

Advertisement

Quick Links

RUE-4136
Remote controller for
DVD navigation System
Owner's Manual
"
#
ENTER
MP
/
/RG
$
%
A.PROC.
MENU
&
VOICE
CANC.
(
)
LIST
N/H
DTR
1
2
3
~
PLAN
5
6
4
+
7
8
9
,
-
DEL.
0
ON/OFF
DEL.DEST.
.
V. SEL.
Map type Navigation Control Mode
1
Remote Control Transmitter
2
Status indicator
3
Joystick/ENTER Button
4
MODE Button
5
MP/RG Button
6
CANC. Button
7
N/H Button
8
Numerick Keypad
9
OK Button
!
DEL. DEST. Button
"
Zoom (Wide) Button
#
AUDIO/NAV. Button
$
Zoom (Detail) Button
%
MENU Button
&
VOICE Button
(
DTR Button
)
LIST Button
~
PLAN Button
+
-
,
-
-
DEL. Button
.
Power ON/OFF Button
Head Unit Control Mode
1
Remote Control Transmitter
R
2
Status indicator
3
Radio mode: Preset Selection (
)
SEEK UP/DOWN (
CD/MD Player/Changer mode: PLAY/PAUSE (Push),
Disc Selection (
Music Sensor (
BW/FF (
Tape mode: PLAY/PAUSE (Push),
Programme Sensor (
4
MODE Button
5
SOURCE Button
6
BAND Button
7
-
8
-
9
(Display Angle Up) Button
!
-
"
Volume Up Button
#
AUDIO/NAV. Button
1
$
Volume Down Button
%
A.PROC. Button
&
MUTE Button
2
(
-
)
3
-
~
-
4
+
-
,
-
5
-
(Display Angle Down) Button
.
Power ON/OFF Button
6
AV Head Unit Control Mode
1
Remote Control Transmitter
7
2
Status indicator
3
Radio mode: Preset Selection (
)
8
SEEK UP/DOWN (
CD/MD Player/Changer mode: PLAY/PAUSE or Audio Mode (Push),
Disc Selection (
9
Music Sensor (
BW/FF (
!
Tape mode: PLAY/PAUSE (Push),
Programme Sensor (
4
MODE Button
5
SOURCE Button
6
BAND Button
7
-
8
Numerick Keypad
9
(Display Angle Up) Button
!
V.SEL. Button
"
Volume Up Button
#
AUDIO/NAV. Button
$
Volume Down Button
%
A.PROC. Button
&
MUTE Button
(
-
)
-
~
-
+
FUNC Button
,
OP./CL. (Display Open/Close) Button
-
(Display Angle Down) Button
.
Power ON/OFF Button
Notes:
• Depending on the unit, some operations cannot be performed. For
details, see the Owner's Manual for the unit.
• After pressing the MODE button, press the following buttons
while the status indicator is blinking:
MAP type navigation: Numerick Keypad (0 to 9), DEL. button, OK button
Head Unit:
(Display Angle Up) Button,
(Display Angle Down) Button
AV Head Unit: OP./CL. Button,
(Display Angle Up) Button,
(Display Angle Down) Button
Installation of Remote Control Holder
L
• If direct sunlight reaches the remote control mounted on
the holder, remove the remote control from the holder and
)
put it in the glove compartment.
• If double-sided adhesive tape cannot install the holder
),
securely, use screws.
),
Note: Attach the blue protective paper side of double-sided
Hold)
tape onto the console box, etc.
), REW/FF (
)
Handling Precautions
Do not drop or apply shock to the unit. It may get perma-
nently damaged.
Keep the unit away from water and moisture, direct sun and
heat, and excessive dust.
Never use scouring pads, steel wool, abrasive powders or
harsh chemical agents, such as lye solution, for cleaning.
Battery Replacement
Applicable battery: Use two "AAA" sized dry batteries or equivalent.
1
)
),
),
Hold)
Opening the battery cover.
Push on the cover and slide it as
), REW/FF (
)
indicated by the arrows then the
cover will be removed.
In Case of Difficulty
Problem
Cause
Remote
Reverse place-
Control
ment of battery.
Inop-
Dead battery.
erative.
Remote Control
not pointed toward
the head unit.
ALPINE ELECTRONICS, INC.
Tokyo office: 1-1-8 Nishi Gotanda,
Shinagawa-ku, Tokyo 141-8501, Japan
Tel.: (03) 3494-1101
ALPINE ELECTRONICS OF AMERICA, INC.
19145 Gramercy Place, Torrance,
California 90501, U.S.A.
Tel.: 1-800-ALPINE-1 (1-800-257-4631)
ALPINE ELECTRONICS OF CANADA, INC.
Suite 203, 7300 Warden Ave. Markham,
Ontario L3R 9Z6, Canada
Tel.: 1-800-ALPINE-1 (1-800-257-4631)
Remote Control
Holder
Double-Sided
Adhesive Tape
(Before attaching
the tape, make
sure the mounting
locations are free
from dust or dirt)
Protective Paper
Clean with a soft, lint-free cloth or cotton swab slightly
dampened with a mild solution of detergent and water.
Do not operate this unit in a manner that could distract you
from driving safety.
2
Replacing the batteries.
Remove the old batteries. Insert new ones
matching the (+) and (–) polarities as shown
in the diagram inside the remote control.
Specifications
Solution
Battery Type ................................................... AAA size batteries
Place the battery correctly into
Battery Quantity ......................................................................... 2
its cradle in the compartment.
Dimensions (W × H × D) ................................. 51 × 36 × 118 mm
Replace the battery with a new
one.
Point the remote control
Weight (without battery) ......................................... 60 gr (2.1 oz)
directly toward your head unit.
R
ALPINE ELECTRONICS OF AUSTRALIA PTY. LTD.
6-8 Fiveways Boulevarde Keysborough,
Victoria 3173, Australia
Tel.: (03) 9769-0000
ALPINE ELECTRONICS GmbH
Kreuzerkamp 7-11 40878 Ratingen,
Germany
Tel.: 02102-45 50
ALPINE ITALIA S.p.A.
Via C. Colombo 8, 20090 Trezzano Sul
Naviglio MI, Italy
Tel.: 02-48 47 81
Remote
Control
Reinforcing Screws
Console Box etc.
3
Closing the cover.
Push the cover in the arrow direction
until a click is heard.
(2 × 1-13/32" × 4-21/32")
ALPINE ELECTRONICS FRANCE S.A.R.L.
(RCS PONTOISE B 338 101 280)
98, Rue De La Belle Etoile, Z.I. Paris Nord Il
B.P. 50016 F-95945, Roissy,
Charles De Gaulle Cedex, France
Tel.: 01-48 63 89 89
ALPINE ELECTRONICS OF U.K., LTD.
13 Tanners Drive, Blakelands,
Milton Keynes MK14 5BU, U.K.
Tel.: 01908-61 15 56
ALPINE ELECTRONICS DE ESPAÑA, S.A.
Portal De Gamarra 36, Pabellón 32
01013 Vitoria (Alava)-Apdo. 133, Spain
Tel.: 34-45-283588
68P20877Y66-O
Printed in China (Y)

Advertisement

loading