AOpen AX4SPE MAX Easy Installation Manual page 2

Everything you need to boot this
motherboard is included in this
Easy Installation Guide. For more
information, a complete
User's Manual can be found in the
Bonus Pack CD. Thanks for the
help of saving our earth.
Easy Installation Guide x 1
User Manual x 1
EzRestore Guide x 1
40-Wire IDE Cable x 1
80-Wire IDE Cable x 1
Floppy Drive Cable x 1
Serial ATA Cable x 2
IEEE1394 Cable x 1
USB2.0 Cable x 1
S/PDIF Cable x 1
SATA Power Cable x 1
Bonus Pack CD x 1
I/O Shield x 1
PART NO: 49.8AT03.EE2 DOC. NO: AX4SPEMAX-EG-E0306B
You can clear CMOS to restore system default setting. To
clear the CMOS, follow the procedure below.
1. Turn off the system and unplug the AC power.
2. Remove ATX power cable from connector PWR2.
3. Locate JP14 and short pins 2-3 for a few seconds.
4. Return JP14 to its normal setting by shorting pin 1 & pin 2.
Online
5. Connect ATX power cable back to connector PWR2.
This motherboard provides keyboard / mouse wake-up function. You can use JP28 to enable or disable this
function, which could resume your system from suspend mode with keyboard or mouse. The factory default
setting is "Disable" (1-2), and you may enable this function by setting the jumper to 2-3.
1. JP14 Clear CMOS
Pin 1
1 1
Normal Clear CMOS
(default)
2. JP28 Keyboard/Mouse Wakeup Jumpers
Tip: When should I Clear CMOS?
1. Boot fails because of overclocking...
2. Forget password...
3. Troubleshooting...
Pin 1
1 1
Disable
Enable
(Default)