Pentair ERICO LANRJ45C6P Instruction Sheet

INSTRUCTION SHEET
LANRJ45C6P
Local Area Network (LAN) Protector
1. General 2. Introduction
The LANRJ45C6P has been designed to provide protection to
Local Area Networks (LAN) from overvoltage surges and electro-
static discharges created by switching transients in buildings. LAN
systems are particularly prone to such disturbances because long
cable lenghts often behave like antennas to such atmosphereic
distrubances. The product is designed to fulfill all versions of POE
applications compatable with IEEE 802.af and IEEE 802.3at.
3. Quick Installation Overview
1. Mount the LANRJ45C6P onto grounded DIN rail
2. Connect the incoming data line into either port
of the LANRJ45C6P
3. Connect the outgoing data line into the
remaining open port of the LANRJ45C6P
WARNING:
1. Pentair products shall be installed and used only as indicated in Pentair product instruction sheets and training materials. Instruction sheets are available at
www.erico.pentair.com and from your Pentair customer service representative.
2. Pentair products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.
3. All instructions must be completely followed to ensure proper and safe installation and performance.
4. Improper installation, misuse, misapplication or other failure to completely follow Pentair's instructions and warnings may cause product malfunction, property
damage, serious bodily injury and/or death, and void your warranty.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
IEEE is a registered trademark of The Institute of Electrical and Electronics Engineers, Inc
Pentair, CADDY, ERICO CADWELD, ERICO CRITEC, ERICO, ERIFLEX, and LENTON are owned by Pentair or its global affiliates. All other trademarks
are the property of their respective owners. Pentair reserves the right to change specifications without prior notice.
TECHNICAL SUPPORT
www.erico.pentair.com
4. Mounting
LANRJ45C6P is designed to
clip onto 35mm (top hat) DIN
rail (standard EN50022) set in
the horizontal position with the
securing clips towards the
bottom of the rail and the label
text facing the correct way up.
IP8362_A 1 of 2
5. Optional Mounting Bracket
The LANRJ45C6P can be used
with an optional mounting bracket
for flat-surface mounting. The additional
mounting bracket comes with a grounding
kit to be used with the product.
© 2016 Pentair All Rights Reserved