Download Print this page

Squelch Threshold - Vertex Standard VXR-9000U-A Alignment Manual

Advertisement

FCC ID: K6610444140
IC ID: 511B-10444140
Alignment
Transmitter Deviation
Microphone Audio Modulation Level
Select band center frequency channel, and adjust the AF generator for 50 mV (-30 dBm) output at 1
kHz to the microphone jack.
Key the transmitter and adjust by control commands for maximum deviation from the computer for 4.2
kHz ± 0.05 kHz deviation as indicated on the deviation meter.
CTCSS Modulation Level
Select band center frequency channel, with 151.4 Hz CTCSS encode, and reduce the AF generator
injection to zero.
Key the transmitter and adjust by control commands for CTCSS deviation from the computer for 0.7
kHz ± 0.05 kHz deviation as indicated on the deviation meter.
DCS Modulation Level
Select band center frequency channel, with DCS 023 enabled, reduce the AF generator injection to
zero.
Key the transmitter and adjust by control commands for DCS deviation from the computer for 0.7 kHz
± 0.05 kHz deviation as indicated on the deviation meter.
Receiver
Set up the test equipment as shown for receiver alignment, and construct the audio test adapter as
described in the box below.
With the transceiver set to band center frequency channel, and the RF signal generator tuned to the
same frequency, set the generator for ±3.0 kHz deviation (for 25 kHz steps) with 1kHz tone
modulation, and set the output level for 1 µV at the antenna jack.
Adjust by control commands for tune from the computer for optimum SINAD, reducing signal generator
output level as necessary for proper meter deflection.
After the previous step, final signal generator level should be less than 0.25 µV for 12 dB SINAD.

Squelch Threshold

Select band center frequency channel, and the RF signal generator turned to the same frequency, set
the generator for ±3.0 kHz deviation with 1 kHz tone modulation, and set the output level for -8 dBµ at
the antenna jack.
Adjust the squelch threshold level by control commands for squelch threshold from the computer so
that it just closes (BUSY LED turns off).
5/5
Vertex Standard Co., Ltd.

Advertisement

loading