Rear Panel - Crest Audio PRO7200 Owner's Manual

3 Features Overview

Rear Panel

1 2
3
Rear Panel
1
Input Connectors
Input signals can be connected to the amp via the Neutrik Combicon
connectors, using either a TRS or XLR connector. Input sensitivity is
.775v (0 dBv) for full rated output power.
See — Input Connections in Chapter 5 for more information.
2
Gain Select Switch
The rear panel Gain Select switch determines whether the amplifier has
an overall gain of 40x (32 dB) or 20x (26 dB).
The OUT position will select x40
The IN position will select x20.
3
Mode Select Switch
The rear panel Mode Select Switch determines whether the amplifier is
in stereo, parallel or bridged mono mode. Do not operate the Mode
Select Switch with the amplifier on.
See — Chapter 4 for more information on operation modes.
p. 10
4
6
5
Rear Panel Legend
Input Connection
Output Connection
Channel A stereo/parallel
Bridged mono
Channel B stereo/parallel
Input Connector Polarity
Table
Speakon Output Polarity
Table
Do not adjust the mode
selection switch while
the amplifier is turned-on.
7
a