Megaworks Thx 6.1 650D By; Controlling Noise And Distortion; Specifications - Creative MegaWorks THX 6.1 User Manual

MWorks THX 650D CLE.book Page 6 Wednesday, January 8, 2003 10:03 AM
Controlling
Noise and
Distortion
MegaWorks THX 6.1 650D has
moderately high input sensitivity, so
it may amplify the hum and hiss
inherent in some audio program
sources. Any noise is not due to a
fault in the speaker system.
You can minimise background noise
as follows:
Use the MegaWorks THX 6.1
❒
650D remote control as your
master volume control.
If your speaker system is
❒
connected to a computer, adjust
the settings of your computer's
sound control software. (If you
are using Creative Sound Blaster
software, this would be the
Surround Mixer application).
Turn off any input controls that
you do not need, such as
Microphone, and set the
6
remaining input controls to about
70% of their maximum volume.
Adjust the master output volume
❒
of your sound control software,
such that your speaker system
reaches a comfortably loud
volume in its default volume
settings.

Specifications

General Specifications
Satellite Power
70Watts RMS per channel (6
channels)
Subwoofer Power
150Watts RMS
Frequency Response
25 Hz ~ 20 kHz
Signal-to-Noise Ratio (SNR):
99 dB
Input Voltage
For Europe/Asia:
230Vac 50/60 Hz 2.5A
For USA:
120Vac 60 Hz 5A
Magnetic Shielding
All satellite speakers are shielded to
allow placement close to display
devices that are sensitive to magnetic
fields.