Page 1
LIVESCOPE ICE FISHING BUNDLE LI ™ INSTALLATION INSTRUCTIONS Important Safety Information WARNING See the Important Safety and Product Information guide in the chartplotter or fishfinder product box for product warnings and other important information. To obtain best performance and to avoid possible damage, you must install this mount using these instructions.
Page 2
40°C (from 68° to 104°F). • Do not connect any cables to the battery that are not approved for this battery by Garmin. • Only replace the battery with the correct replacement battery. Using other batteries presents a risk of fire or explosion.
Page 3
Charging the Battery WARNING Do not connect any cables to the battery that are not approved for this battery by Garmin. Only use the included all-in-one cable and charger to charge the battery. Ensure that you connect the correct connector to the correct battery terminal. Damage to the battery or device, or bodily harm may occur if the device is improperly connected to the battery.
Page 4
Assembling the Panoptix Ice Fishing Mount ™ You need a Phillips screwdriver and the included 5 mm hex wrench to assemble the ice fishing mount and attach the transducer. 1 Insert the Phillips head sheet metal screws into the four corners of the ice mount base. The screws protrude from the bottom of the base to help stabilize the mount when it is on the ice.
Effective Forward and Down Range NOTE: Water conditions and bottom conditions affect the depth and range performance of the transducer. You should use caution and observe the water depth and range, especially when your unit is operating in manual range or depth mode. When operating in LiveVü...