Contents Safety and warnings Installation instructions Getting started quickly Cleaning and maintenance Manufacturer’s Warranty Customer Care Important! SAVE THESE INSTRUCTIONS The models shown in this User Guide may not be available in all markets and are subject to change at any time. For current details about model and specification availability in your country, please visit our local website listed on the back cover or contact your local Elba dealer.
Safety and warnings Important! Please read the entire set of instructions before installing the wall canopy. ■ ■ This wall canopy is not intended for use by young children or infirm persons without supervision. ■ ■ Young children should be supervised to ensure that they do not play with the wall canopy. ■...
Installation instructions Contents of packaging 1 x wall canopy ■ ■ 2 x chimney flues with bracket ■ ■ 1 x installation instructions ■ ■ 2 x aluminium mesh filters (HC60PCIX3) ■ ■ 3 x aluminium mesh filters (HC90PCIX3) ■ ■ 2 x butterfly flaps ■...
Page 6
Installation instructions Height of wall canopy Where an electric cooktop is installed beneath the wall canopy, the distance between the top ■ ■ of the cooktop and the underside of the range hood must be a minimum of 600 mm and a maximum of 700 mm.
Page 7
Installation instructions Preparing the wall canopy for installation Before installing the wall canopy, please carefully read through the installation instructions ■ ■ in full. Prior to drilling any holes, check that the area behind the surface to be drilled is clear of any ■...
Page 8
Installation instructions Establish the desired height of the rangehood above the benchtop according to the ‘Installation height requirements’ above. Measure this distance from the top of the benchtop and, using a spirit level, draw 60 – 75 cm a light horizontal line on the wall. Make sure that the line can easily be erased or will be hidden after installation.
Page 9
Installation instructions Drill holes and secure the rangehood to the 290 mm wall. Depending on the wall type (concrete, drywall etc) drill/screw appropriate fittings in the two locations just marked. The rangehood should now be able to be hung on these bolts/ screws through the two keyholes in the hood.
Getting started quickly Control panel Fig.7 Slide control 3 = Fan On / High 2 = Fan On / Medium 1 = Fan On / Low 0 = Fan Off 1 = Lights On 0 = Lights Off...
Cleaning and maintenance Caution! Never use abrasive or oil based liquid cleaners. General maintenance The manufacturer is not liable for any damage caused by not following these instructions. The wall canopy should be cleaned regularly using warm water with soap or mild liquid detergents.
Page 12
Cleaning and maintenance Light bulb replacement (Screw-in 230V/Max 25W) Switch off the power to the wall canopy. Remove the aluminium mesh filters (or charcoal filters if fitted). Unscrew the old bulb, and screw in the new replacement bulb. Refit aluminium mesh, or charcoal filters. Note: replacement bulbs are not covered by warranty.
Manufacturer’s Warranty You automatically receive a 2 year Manufacturer’s Warranty with the purchase of this Product covering parts and labour for servicing within the country of purchase. Fisher & Paykel undertakes to: Repair or, at its option, replace without cost to the owner either for material or labour any part of the Product, the serial number of which appears on the Product, which is found to be defective within TWO YEARS of the date of purchase.
Customer Care Before you call for service or assistance… Check the things you can do yourself. Refer to your User Guide and check: Your appliance is correctly installed. You are familiar with its normal operation. If after checking these points you still need assistance, please refer to your nearest Fisher & Paykel Authorised Repairer, or contact us through our local website listed on the back cover.