Advertisement
Yellow Warning Sign indicates
Tensioner is in RELEASE MODE,
DO NOT transport occupant when visible.
SECURING
REAR
1. Attach shoulder belt pin connector
to pin on wall side lap belt, then
secure seatbelts onto the storage
pin under flip-up seat
.
2. Backup wheelchair to park zone
3. Pull paddle handle
to release
rear retractors and activate
XPress Timer.
4. Attach both rear J-hooks to rear
wheelchair frame
.
5. Backup wheelchair within park
zone
and against side bumper
or closest proximity.
FRONT
Make sure Tensioner is in
release mode
.
6. Attach front J-hook to front
wall side wheelchair frame
For scooters, loop J-hook around
front wheel frame, and then
insert J-hook (facing out) through
O-ring
.
7. Press button
, pull down
tension handle
, release
button, and crank handle until full
tension is reached and clutch slips.
Make sure Warning Sign
NOT visible.
8. Lock wheels
or power off
chair.
SEATBELTS
9. Extend shoulder belt and wall side
lap belt across occupant's shoulder
and hip
; then buckle them to
the aisle side lap belt
.
Buckled seatbelts should be
against occupant's
hipbone
.
10. Occupant and wheelchair are
secured and ready to go.
OPERATING INSTRUCTIONS
.
.
is
IMAGES
A
C
D
E
park zone
B
ex: J-hook tie-down
J
wheelchair
scooter
release mode
RELEASING
SEATBELTS
1. Detach shoulder belt pin connector
from pin on lap belt
2. Unbuckle lap belt
all seatbelts in storage.
If needed, press seatbelt
release button
FRONT
3. Press button
tension handle
button to release front J-hook
tension
4. Remove front J-hook from
wheelchair frame
scooter
. Place J-hook in
storage ring
5. Unlock wheels
chair.
REAR
6. Pull paddle handle
K
rear retractors and activate
XPress Timer.
7. Move wheelchair forward, remove
rear J-hooks from rear wheelchair
frame and place J-hooks in
storage
.
8. Occupant and wheelchair are
released and ready to go.
.
and place
.
, push back
and release
.
or
.
or power on
to release
Advertisement
