Usb/Sd Playback; Troubleshooting; Fcc Statements - Crosley Harmony CR3037B Instruction Manual

English

USB/SD Playback

1. Press the Mode Button repeatedly to select the USB (Green) or SD (Purple)
mode.
2. Insert a USB device into the USB port or a SD memory card into the SD card
slot.
3. To skip to the next or previous track, press the Forward Skip or Backward
Skip button correspondingly.
4. During the playback, press the Play/Pause button to pause. Press it again to
resume playback.

Troubleshooting

There is no power
• No power at the power outlet.
• Power adaptor is not connected correctly.
There is no sound
• Make sure the volume is turned up.
• Mode is in the Bluetooth position.
• Make sure the volume on your third party device is turned up.

FCC Statements

NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may
cause undesired operation.
6