Table of Contents
Advertisement
QUICK REFERENCE GUIDE
4
Accessing setpoints via the front panel
469 MOTOR MANAGEMENT RELAY – QUICK REFERENCE GUIDE
Refer to the Changing setpoints section in Chapter 1 of the 469 Instruction Manual. Note
that to have access to the relay setpoints, you must install a hardware jumper across
terminals C1 and C2 at the back of the relay case. Attempts to enter a new setpoint
without this electrical connection will result in an error message. Important additional
information is provided in the same section regarding passcode, and accessing
information via the serial ports of the relay.
11
Advertisement
Table of Contents
