Emptying The Dust Cup; Cleaning And Replacing The Filters - Shark UV700 Series Owner's Manual

EMPTYING THE DUST CUP

IMPORTANT: Unplug the power cord before performing any maintenance.
To remove Dust Cup, slide up the buttons on
both sides of the handle. Tilt dust cup, then lift
to remove.
To remove collected debris from Lint Screen,
press top release button and lift handle to
open. Gently brush lint screen to clean.
s h a r kc l e a n . c o m
To empty debris, press lower release button
and bottom of dust cup will drop open.
To reinstall, place bottom of dust cup into
pod and then tilt until it clicks into place.

CLEANING AND REPLACING THE FILTERS

CLEANING FILTERS
Regularly rinse and replace the filters to maintain your vacuum's suction power.
To prevent damage from cleaning chemicals, rinse filters with cold water only. Allow all filters
to air-dry for at least 24 hours before reinstalling them to prevent liquid from being drawn into
electric parts.
IMPORTANT: DO NOT use soap when cleaning the filters.
CLEAN PRE-MOTOR FILTERS
EVERY 3 MONTHS
Remove Dust Cup, then lift out Filters.
Filter Access
Filter
Cover
CLEAN HEPA FILTER
EVERY YEAR
Press Filter Access button at bottom of
Filter Cover. Tilt cover and lift out. Remove
HEPA Filter.
To reinstall, insert HEPA filter into unit and
replace the cover.
s h a r kc l e a n . c o m