Advertisement
2
3
4
5
1
For Models with Soap Dispenser
Remove the bottle (1). Separate head (2) from body
assembly (3). Make sure gasket (4) is properly seated in
the base of the body assembly. Insert body assembly
through selected hole in sink. Secure body assembly to
sink with nut and gasket (5). From under the sink screw
the bottle (1) onto the body assembly shank, then
attach head assembly. Note: To fill, lift the head and
pump assembly out of the bottle and pour not more
than 8 oz. into bottle. DO NOT remove the bottle each
time as this weakens the neck. Use a funnel to help
prevent spills. Pull pump and head assembly out
occasionally to soak and pump warm water through
pump to remove soap build-up. Note: Initially it may take
up to 12 pumps to bring soap to the pump tip.
8
50113
Rev. B
Advertisement
