Bryant PREFERREDT A07044 Installation Instructions Manual page 22

Fig. 14 - - Equipment Control Module
5. Match and connect equipment wires to proper terminals of each connector
block.
6. Push any excess wire into wall and against Equipment Control Module.
Seal hole in wall to prevent air leaks. Leaks can affect operation and cause
incorrect temperature and/or humidity measurement.
7. Remove 2- -wire pigtail from Thermidistat Control mounting base and at-
tach to Equipment Control Module terminal block (terminals V+ and
Vg). Attach two- -wire pigtail to the back of the Display Module via 2 pin,
keyed connector.
8. Reattach Display Module body to Equipment Control Module by first
setting on at top and then push bottom corners to snap into place. See Fig.
15.
22
A07219