Adjusting The Crossover; Setting The Bass Boost; Final System Checks - Clarion XH5410 Owner's Manual & Installation Manual

7. Turn the volume back down slightly.
8. Slowly increase the gain control (clockwise). Stop when you hear a slight audio
distortion.
When the gain is properly set, you should achieve maximum undistorted output with
the volume turned up all the way, not half way.
If an oscilloscope is available, monitor the output of the amplifier with the scope,
watching for clipping of the waveform. Set the gain so that only minor clipping occurs.

Adjusting the crossover

The XH510 and XH5410 amplifiers feature fully-adjustable crossovers.
The XH7110 does not have a way to disable the low-pass 4dB slope crossover.
1. On the XH510 and XH5410, use the X-Over mode switch to select either LP (low
pass) or HP (high pass) or OFF for full range.
. Using the Frequency (Hz) selection control, select the frequency.

Setting the bass boost

1. Initially set the bass boost control to the OFF position.
. Listen to a variety of music styles (for example, rock, rap, etc.) and switch the
bass boost control on until you notice an increase in low bass response.
Note:
Using the bass boost requires the amplifier to produce a great deal of
additional power. Use bass boost sparingly.
If you hear a pop caused by speaker overexertion, lower
the bass boost to prevent damage to the speaker.

Final system checks

1. Start the engine and turn on the source unit.
. After a two-second delay, slowly increase the volume control and listen to the
audio.
If you hear any noise, static, distortion or no sound at all, check the connections
and refer to Troubleshooting. Depending on your system, the volume may become
quite loud even at moderate volume control settings. Until you get an "audio feel"
for the system's power, use care when adjusting the controls.
. Turn the balance controls to their extreme positions and listen to the results.
Audio output should match control settings (audio from the left speaker when
balance is left).
4. Increase the volume and verify that the amplifier reproduces the audio at full
frequencies without distortion.
If you hear distortion check the connections and verify that the gain control is set
correctly. Another cause of distortion could be underpowered or damaged
speakers. Refer to Troubleshooting.
0
XH510/XH5410/XH7110
CAUTION