Table of Contents
Advertisement
1. Turn off everything (unless instructed otherwise).
2. Remove the power cords from the outlets.
3. Remove the signal cables from the connectors.
4. Remove all cables from the devices.
To connect:
1. Turn off everything (unless instructed otherwise).
2. Attach all cables to the devices.
3. Attach the signal cables to the connectors.
4. Attach the power cords to the outlets.
5. Turn on the devices.
•
Sharp edges, corners and joints may be present in and around the system. Use care
when handling equipment to avoid cuts, scrapes, and pinching. (D005)
The following CAUTION notices appear in this manual:
Caution Notice C049
CAUTION: The battery used in this device contains Lithium, which might present a risk of fire or
chemical burn if mistreated. Do not disassemble, heat above 100 degrees Celsius, burn,
incinerate, or crush. Dispose or recycle promptly and properly as instructed by local regulations.
Replace battery with an equivalent type or module recommended by the manufacturer only. Use
of another battery might present a risk of fire or explosion. (C049)
Exchange only with Renata CR2477 Coin cell batteries, other brands will not work with the
battery connector. Recycle or discard the battery as instructed by local regulations.
© Copyright IBM Corp. 2021
9
Advertisement
Table of Contents
