Table of Contents
Advertisement
Chapter 3: Terminal Menu Operation and Structure
RIP/Triggered
Write security: 3; Read security: 5
When set to Yes, only IP RIP updates are sent when the routing table has
changed and learned routes are not "aged." When set to No (def), updates are
sent periodically.
PPP Profile/IPX
The IPX menu contains the parameters for exchanging IPX data with the PPP
peer.
IPX/Mode
Write security: 3; Read security: 5
Setting to On (def) will permit this connection profile to negotiate PPP IPXCP
with the PPP peer for exchanging of IPX packets.
IPX/Remote Network
Write security: 3; Read security: 5
A non-zero value in this remote network number will allow the Express L768/
L1.5 to add a route to the PPP peer's network to the routing table.
The Express L768/L1.5 normally will treat the WAN network as an unnum-
bered link. This is usually referred to as being a "half-router." However, a
PPP peer which wants to assign a network address to the WAN link can do so,
in which case the Express L768/L1.5 will go into "full-router" mode.
IPX/Triggered
Write security: 3; Read security: 5
When set to Yes, only IPX RIP and SAP updates are sent when the routing or
service table has changed and learned routes are not "aged." When set to No
(def), updates are sent periodically based on the RIP and SAP timers set in
Configuration/IPX/RIP Timer and Configuration/IPX/SAP Timer.
IPX/Type 20 Packets
Write security: 3; Read security: 5
In order for certain protocol implementations, like NetBIOS, to function in the
NetWare environment, routes must allow a broadcast packet to be propagated
throughout the IPX networks. The Type 20 IPX packet is used specifically for
60
Express L768/L1.5 User Manual
61202192L1-1
Advertisement
Table of Contents
