Inspection And Maintenance - Mitsubishi Outlander PHEV 2019 Manual

Inspection and maintenance

NOTE
2 • Certain front, side or rear collisions.
• Certain Plug-in Hybrid EV system mal-
functions.
l
When the emergency shut-off system is acti-
vated, the ready indicator is turned off. Refer
to "Indicator and warning lamp list" on page
6-24.
l If the emergency shut-off system activates,
contact a MITSUBISHI MOTORS Author-
ized Service Point.
Inspection and maintenance
When performing inspection and mainte-
nance, be careful in the following points.
WARNING
l Before performing inspection or mainte-
nance, be sure to disconnect the charge
connector from the vehicle and confirm
that put the operation mode of the power
switch in "OFF".
2-08 General information
WARNING
l Never touch, disassemble, remove or re-
place highvoltage parts, exposed electrical
components, cables or connectors. Failure
to follow this instruction can result in se-
vere burns or electric shock causing seri-
ous injury or death. High-voltage cables
are colored orange. The vehicle high volt-
age system has no user serviceable parts.
Take your vehicle to a MITSUBISHI
MOTORS Authorized Service Point for
any necessary maintenance.
l Never touch the service plug under the
rear seat. Improper handling of this could
cause an electric shock which result in a
E00205400031
serious injury or death. The service plug
is used to shut off the high voltage from
the drive battery when repairing the vehi-
cle at a MITSUBISHI MOTORS Author-
ized Service Point.
High-Voltage components
OGGE19E1
1- On board charger/DC-DC converter
2- Rear motor
3- Service plug
4- Electric heater*
5- Drive Battery
6- Front motor
7- Generator
8- Air conditioner compressor
9- Power drive unit (PDU)
10- Rear electric motor control unit (MCU)
11- Normal charge port/Quick charge port
WARNING
l The Plug-in Hybrid EV System uses high
voltage up to DC 300 volt. The system can
be hot during and after starting and when
the vehicle is shut off. Be careful of both
the high voltage and the high tempera-
ture. Follow the warning labels that are
attached to the vehicle.
l Always assume the high voltage battery
and associated components are energized
E00205500032
and fully charged.
l Never perform servicing when READY
indicator is illuminating or when the
charging indicator is illuminating or
flashing because the high-voltage system
is operating.