Query Control Gear Groups; Add Control Gear To Groups - Siemens SIMATIC ET 200SP CM 1xDALI Programming Manual

CM 1xDALI command list
3.4 Configuration
3.4.7

Query control gear groups

Description
Command ID 27
Input Param-
eters
Response
Parameters
3.4.8

Add control gear to groups

Description
Command ID 28
Input Param-
eters
Response
Parameters
38
Use this CM command to query the group membership information of a control gear.
Byte 0 Short address of the control gear
Byte 1 Query actual device flag.
0: query the group membership information saved in CM 1xDALI.
•
1: query the group membership information on the device.
•
Byte 0 Return code (Page 51)
Byte 1
0: queried group membership in CM 1xDALI.
•
1: queried group membership on the device.
•
Byte 2 Membership of group 0 to 7:
Each bit indicates one group. For example, Bit 0 is for group 0, bit 1 is
for group 1.
1: control gear is added to this group.
•
0: control gear is not in this group.
•
Byte 3 Membership of group 8 to 15:
Each bit indicates one group. For example, Bit 0 is for group 8, bit 1 is
for group 9.
1: control gear is added to this group.
•
0: control gear is not in this group.
•
Use this CM command to add the control gear to some groups.
Byte 0 Short address of the control gear
Byte 1 Add to group 0 to 7.
Each bit indicates one group. For example, Bit 0 is for group 0; bit 1 is
for group 1.
1: add to this group
•
0: no action
•
Byte 2 Add to group 8 to15.
Each bit indicates one group. For example, Bit 0 is for group 8; bit 1 is
for group 9.
1: add to this group
•
0: no action
•
Byte 0 Return code (Page 51)
ET 200SP CM 1xDALI Communication Model Description
Programming Manual, 12/2019, A5E47581955-AA