Notes On The Installation Location - Epson ELPMB64 Installation Manual

Short throw projector wall mount
Table of Contents

Advertisement

Introduction
Route the cables so that they are not interfered with the nuts and bolts.
Incorrect handling of the cables may cause fire or electric shock.
When turning on the projector, do not look into the projection lens.
This could cause damage to eyesight due to the powerful light emitted. Take particular care when
there are children present. When turning on the projector at a distance using the remote control,
make sure there is no one looking into the projection lens.
When using the projector, do not place any objects near the projection lens or put your
hand near the projection lens.
This area is dangerous as it reaches a high temperature due to the concentrated projection light.
Do not use the projector in a location subject to combustible or explosive gas.
High temperatures within the projector may cause ignition and a fire to occur.
Only a specialist should remove or reinstall the projector, including for maintenance and
repairs.
See the projector's User's Guide for instructions on maintenance and repairs.
If any abnormalities occur with this product, immediately disconnect the cables from the
product, and then contact your local dealer or the nearest Epson service call center.
Continuing to use the product in an abnormal condition could cause a fire, electric shock, or visual
impairment.
Do not install the product in a location where the operating temperature of the projector
might be exceeded.
Otherwise, damage may result.
Install the product in a location free from humidity and dust to prevent the projector's lens
and optical components from becoming dirty.
Do not use excessive force when adjusting this product.
This product may break, resulting in personal injury.
Do not disassemble the projector when disposing of it.
Dispose according to your local or national laws and regulations.

Notes on the Installation Location

Do not install in a location subject to oily smoke or smoke for events.
If oils and so on stick to the slide plate fixing part of the projector, the case may crack and cause
the projector to fall, resulting in personal injury or property damage.
Warning
Caution
Warning
3

Advertisement

Table of Contents
loading

Table of Contents