Accessing/Managing Switch Using Web Interface; Configuring The Cisco Small Business Smart Switch - Cisco SF 200-24P Quick Start Manual

PoE is available on the following ports:
Model
SF 200-24P and SG 200-26P
SF 200-48P and SG 200-50P
Use the following table to determine the total power budget available for
all devices on your switch.
Model
SF 200-24P
SF 200-48P
SG 200-26P
SG 200-50P
Configuring the Cisco Small Business
3
Smart Switch
Before You Begin
Verify that a computer with Microsoft Internet Explorer (version 6 or higher)
or Firefox (version 2.0 or higher) is available.
Accessing and Managing Your Switch Using the Web-
Based Interface
In order to access the switch with a web-based interface, you must know
the management IP address of the switch. The default configuration of the
switch is to use its factory default IP address of 192.168.1.254 until it has
obtained an IP address from a DHCP server, or it has been changed to a
static IP address.
When the switch is using the factory default IP address, its System LED
flashes continuously. When the switch is using a DHCP assigned IP
address or an administrator configured static IP address, the System LED
lights steady.
If the smart switch IP address is changed, either by a DHCP server
N
OTE
or manually, your access to the smart switch will be lost and you must
use the new IP address to configure the device.
To configure the smart switch:
Power on the computer and the switch.
S 1
TEP
Connect the computer to the switch. You can connect to the same
S 2
TEP
IP subnet as the switch by connecting them directly with an
4
Power Dedicated to PoE
100 Watts
180 Watts
100 Watts
180 Watts
Ports
1—6 and 13—18
1—12 and 25—36
200 Series Smart Switches