Setting Up A Network - Cisco MDS 9148 Quick Start Manual

Send documentation comments to mdsfeedback-doc@cisco.com
Figure 6 Power Receptacle and On/Off Switch on Cisco MDS 9148 Switch
On/Off
switch
6

Setting Up a Network

To set up a network, follow these steps:
Step 1 Ensure that the Mgmt0 port is connected to the management network.
Ensure that the console port is connected to the PC serial port (or to a terminal server), as shown in
Step 2
example, on a Windows PC used as a terminal emulator, you can use HyperTerminal. The default baud rate on the
console port is 9600.
Figure 7 Connection to Terminal Emulator.
Console port
See Figure 1
Note
6
AC power
receptacle
Teminal
emulator
for the physical location of the Mgmt 0 port and console ports.
Figure 7. For