Interlock Switch Operating Check - Mitsubishi Eclipse 1990 Service Manual

Interlock switch
CLUTCH
On-vehicle Service

INTERLOCK SWITCH OPERATING CHECK

Lock the front wheels, apply the parking brake and put
1.
the shift lever in the
2. After normally adjusting the clutch pedal, check the inter-
lock switch operation as follows:
(1) The engine should not start even if the ignition switch
is turned to "START" position with the clutch pedal
not depressed. If the engine should start, check the
interlock switch
(2) The engine should start after the clutch has been
disconnected while the clutch pedal is depressed with
the ignition switch turned to "START" position.
If the engine should start before the clutch pedal
is disconnected or the engine does not start even
if the clutch pedal is depressed, adjust the interlock
switch.
INTERLOCK SWITCH CHECK
21100110045
1. Check to be sure that the interlock switch is as shown
in the illustration when the clutch pedal is depressed
at its full stroke
the lock nut and adjust.
2. Connect an ohmmeter to the interlock switch connector,
and then check for continuity when the clutch pedal -is
fully depressed and when it is released outward.
Pedal position
fully depressed
released
Revision
gear.
harness.
mm If necessary, loosen
Terminal No.
1
I
0
2
0