Resettin g the CPU
Resetting the CPU clears all memories, re
peater shifts and other settings to their de
faults, and leaves the transceiver CPU in the
same state as when it left the factory.
A soft reset can be done by holding the
D/MR and REV keys while switching the
transceiver on. If a CPU-related problem re
mains after the soft reset, a hard reset can be
done as follows:
D
Turn the transceiver off, and disconnect all
cables.
D
Remove the top and bottom covers and the
front panel, as shown in Case Disassembl y on
page 1-2.
FT- 5100
Technical Supplement
Servicing
D
Remove 15-.Q chip resistor R1031 from the
Main Unit.
Temporarily s h ort across capacitor C5002.
D
D
Install another 15-.Q (chip or leaded) resistor
in the same place where R1031 was re
moved.
D
Replace the front panel and covers.
C5002
R1031
2 -9