National Instruments PXIe-4143 Safety, Environmental, And Regulatory Information

SAFETY, ENVIRONMENTAL, AND REGULATORY INFORMATION
PXIe-4143
PXIe, 4-Channel, ±24 V, 150 mA Precision PXI Source Measure Unit
Read this document and the documents listed in the additional resources section about installation, configuration, and operation of this equipment before you
install, configure, operate, or maintain this product. Users are required to familiarize themselves with installation and wiring instructions in addition to
requirements of all applicable codes, laws, and standards.
Regulatory Icons
Notice—Take precautions to avoid data loss, loss of signal integrity, degradation of performance, or damage to the model.
Caution—Take precautions to avoid injury. Consult the model documentation for cautionary statements when you see this icon printed on the model.
Cautionary statements are localized into French for C-UL certification.
Warning—Take precautions to avoid electrical shock.
Safety
Caution Observe all instructions and cautions in the user documentation. Using the model in a manner not specified can damage the model and
compromise the built-in safety protection. Return damaged models to NI for repair.
Attention Suivez toutes les instructions et respectez toutes les mises en garde de la documentation utilisateur. L'utilisation d'un modèle de toute autre
façon que celle spécifiée risque de l'endommager et de compromettre la protection de sécurité intégrée. Renvoyez les modèles endommagés à NI pour
réparation.
Safety Voltage and Current
Notice The protection provided by the PXIe-4143 can be impaired if it is used in a manner not described in the user documentation.
DC voltage
Range
Continuous isolation, any pin to earth ground
Transient overvoltage
Caution Do not connect the PXIe-4143 to signals or use for measurements within Measurement Categories II, III, or IV.
Attention Ne connectez pas le PXIe-4143 à des signaux et ne l'utilisez pas pour effectuer des mesures dans les catégories de mesure II, III ou IV.
Measurement Category I is for measurements performed on circuits not directly connected to the electrical distribution system referred to as MAINS voltage.
MAINS is a hazardous live electrical supply system that powers equipment. This category is for measurements of voltages from specially protected secondary
circuits. Such voltage measurements include signal levels, special equipment, limited-energy parts of equipment, circuits powered by regulated low-voltage
sources, and electronics.
Note Measurement Categories CAT I and CAT O are equivalent. These test and measurement circuits are for other circuits not intended for direct
connection to the MAINS building installations of Measurement Categories CAT II, CAT III, or CAT IV.
DC current range
EMC Guidelines
This product was tested and complies with the regulatory requirements and limits for electromagnetic compatibility (EMC) stated in the product specifications.
These requirements and limits provide reasonable protection against harmful interference when the product is operated in the intended operational
electromagnetic environment.
This product is intended for use in industrial locations. However, harmful interference may occur in some installations, when the product is connected to a
peripheral device or test object, or if the product is used in residential or commercial areas. To minimize interference with radio and television reception and
prevent unacceptable performance degradation, install and use this product in strict accordance with the instructions in the product documentation.
±24 V
60 VDC, CAT I
1,000 V RMS, verified by a 5 s withstand
±150 mA