Appendix B: Electrical Specifications For Vsp F400, F600; Electrical Specifications - Hitachi F400 Hardware Reference Manual

Appendix B: Electrical specifications for VSP
F400, F600
The electrical specifications are described for the storage systems.

Electrical specifications

Item
Frequency (Hz)
Number of phases, cabling
Steady-state current 100V/
1 2
200V ,
Current rating of breaker/
fuse (A)
Heat value (normal) (kJ/h)
Steady-state power (VA/W)
Power consumption (VA/W)
Notes:
1. The power current of Nx2 described in this table is required for a single power unit.
2. If one power unit fails, another power unit requires electric current for the two power
units. Therefore, plan the power supply facility so that the current-carrying capacity for
one power unit can provide the total capacity for two power units.
3. This table shows the power requirement (100 V or 200 V) for the maximum
configuration . The actual required power might exceed the value shown in the table
when the tolerance is included.

Appendix B: Electrical specifications for VSP F400, F600

Hitachi Virtual Storage Platform F400, F600 Hardware Reference Guide
Controller
50/60 ±1
Single-phase with protective grounding
CBLM: 4.0x2
16.0 (each electrical)
CBLM: 2160 or less
3
CBLM: 1600/1560 or less
CBLM: 640/600 or less
Drive tray
FMD drive tray: 2.6x2/1.3x2
FMD drive tray: 1520 or less
FMD drive tray: 1520 or less
FMD drive tray: 520/490 or
less
FMD drive tray: 440/420 or
less
55