Refitting The Throttle Body - Ducati MULTISTRADA 1200S ABS 2015 Workshop Manual

Refitting the airbox and throttle body

REFITTING THE THROTTLE BODY

Working on both intake manifolds, ensure that O-rings (26) and (27) are installed on injectors (23).
Apply the indicated grease on the O-rings (26) and (27) of injectors (23), thoroughly avoiding to leave any
product residue on injector surface and using the quantity of product strictly necessary to carry out the following
assembly operations.
Insert injector (23) onto fuel pipe unit union (28).
Important
To avoid damaging the O-rings, drive the injector fully home on the throttle body, keeping it in line with its seat.
Holding the unions (29) pressed down on the injectors, start and tighten screws (30) fully home.
Tighten the retaining screw (30) to a torque of 5 Nm ± 10% ensuring that during this operation the teeth
highlighted in the figure remain in the indicated position.
Secure the union with clip (31).