Model Specifications; Package Contents; Assembly And Pre-Flight Check - Banana Hobby BLITZRCWORKS V-22 OSPREY Pilots Operating Manual

Table of Contents

2: Model Specifications (ARF)

• Wingspan: 700mm (Without Motor Nacelles)

• Length: 848mm

• Weight: 1150g (Without Battery)

• Motor: (2) 3510 brushless motors, (1) 2520 brushless motor (EDF)

• Battery: 4S 2200MAH - 2800MAH (Flight time 3-7 minutes, varies on battery/flying

style)

• ESC: (2) 30A Brushless ESC (1) 20A Brushless ESC

• Servo: (3) 9g Standard and (2) 17g Metal Gear Servos

Features:

With our advanced VTOL technology, this model is capable of switching between

hovering/landing like a helicopter (VTOL) to flying like a standard fixed wing airplane. Some of

its capabilities include flying like a helicopter/multirotor to flying like an airplane. It's capable of

maneuvers such as rolls, loops, and other aerobatic stunts, but exercise extreme caution.

3.1 Airframe (Fuselage, Main Wing, Horizontal and Vertical Stabilizers)

3.2 Propeller Assembly (Left and Right Blade Sets and Spinner Sets)

3.3 Landing Gear Set

3.4 Manual Booklet

3.5 4S 2200mAh Lithium-Polymer Battery (RTF ONLY)

3.6 Balance Charger (RTF ONLY)

3.7 Transmitter and Receiver (RTF ONLY)

3.8 M3 Hex Wrench

This model arrives partially assembled. The fuselage has been mostly assembled and tested at

the factory, but additional assembly is required for the tail section.

4.1 You will require glue such as foam-safe epoxy to attach the vertical and horizontal stabilizers

to the fuselage. Epoxy or CA glue(Foam-safe) is suggested. Make sure to center the

two vertical stabilizers parallel to the centerline of the fuselage, as shown on the images

below. Always test fit the vertical stabilizers and horizontal stabilizer to insure proper

fitment before applying adhesive. Remove any paint on the surface where glue will be

applied for a stronger adhesion. TIP: You can use packing tape, clear scotch tape to

remove the paint from areas where glue will be applied. Simply press the tape on the

areas and peel the tape off. Most time the paint will peel away with the tape.

Table of Contents