Dynex DX-32L150A11 Service Manual page 7

2.2 Alignment flow-chart
The alignment flow-chart is shown below (Fig. 1) :
Input test signal, check TV all performance (such as all programs are searched,
analog control, etc.). Check if headphone and speaker output normally.
3. Alignment instructions
3.1 The whole unit alignment
3.1.1 According to the wiring diagram, connect Data Process Board, Power Board, Key board, IR
Board. Connect AC 120V power and turn on the TV, check if the display is normal.
3.1.2 The way to use Factory Menu
a) Press INPUT button, then in turn press "2", "5", "8", "0" to enter the Factory Menu.
b) Press CH+ or CH- to select items, then press OK to enter.
c) Press CH+ or CH- to move the highlight up or down.
d) Press VOL- or VOL+ to adjust the selected item.
e) Press MENU to return to the previous menu.
f) Press EXIT to close the Factory Menu.
ALIGNMENT INSTRUCTIONS
Check if DDC, FLASH is written?
Make Data Processing Board
Mounting alignment (Check if the voltage is 120V)
White balance alignment
Input AV/SVIDEO signal, check if the AV jacks perform normally.
Input HD signal, check if YPbPr jacks perform normally.
Input VGA signal, check if the display is normal. Check all
performance (analog control), H-center, V-center, etc.
Input HDMI signal, check if the display is normal. Check all
performance (analog control), H-center, V-center, etc.
Check accessories, packing
Fig.1 Alignment flow-chart
Ex-factory preset
6