Sharp LC-60LE745U Service Manual page 27

2.2.3 How to upgrade the software
1. Unplug the AC cord.
2. Insert the USB Memory for version upgrade into the service socket.
3. Plug in the AC cord with power button pressed down.
4. After 5 seconds, unpress the power button.
5. After the unit startup, the system upgrade screen as shown below within 20-40 seconds.
6. Even a single failure in the process will trigger the upgrade failure screen.
NOTE: In the event of a failure, repeat the upgrade process. If the process repeatedly fails, it is likely that the hardware need fixing.
7. Upon completion of the whole process, the upgrade success screen as shown below appears. You can check the new software version on this
screen. The version information appears after the upgrade is complete.
8. Unplug the AC cord and remove the USB Memory for version upgrade.
9. Now the software version upgrade is complete.
NOTE: When you are done with the software version upgrade, start the set, go to the top page of the adjustment process screen and check the main
software version information.
LC-60/70LE745U,C7450U,LE845U,C8470U,LE847U (1st Edition)
Software Update
MAIN
SUB MICOM
PANEL EEPROM
IR MICOM
MAIN Version
SUB MICOM Version
PANEL EEPROM
IR MICOM Version
Software Update
UPGRADE FAILURE
MAIN
SUB MICOM
PANEL EEPROM
IR MICOM
MAIN Version
SUB MICOM Version
PANEL EEPROM
IR MICOM Version
Software Update
UPGRADE SUCCESS
MAIN
SUB MICOM
PANEL EEPROM
IR MICOM
MAIN Version
SUB MICOM Version
PANEL EEPROM
IR MICOM Version
5 – 2
60LE745U
50%
NO DATA
NO DATA
OK
U1007071
1.00
60LE745U
Project ID
NO DATA
NO DATA
OK
1.00
60LE745U
100%
NO DATA
NO DATA
OK
U1007071
1.00