Advertisement
Quick Links
1. Plug the Light Control receiver into a 120 Volt AC polarized outlet.
NOTE: The plug contacts are designed for polarized outlets only.
2. Plug a light into the polarized receiver outlet.
3. TURN on the light.
4. TO TEST: Press and release the receiver actuator. Light should turn on.
Press the remote control push button. Light should turn off.
NOTE: If two or more light products are installed, receivers must
be located at least 10 feet apart to prevent electronic interference.
If receiver does not activate light, check to be sure:
1. Light is turned on.
2. Light and receiver are firmly plugged in.
_
3. There is power to outlet (check fuse box or circuit breakers).
If remote control does not activate light, check to be sure:
1. Receiver and remote have matching code settings.
2. You are pressing the remote control push button selected to
operate the Light Control (with Multi-Function remotes.)
3. Remote control battery has power. NOTE: Test light on the
remote should glow when the push button is pressed. (Battery
changing information is included in instructions packed with
your transmitter.)
Model 772CB
Wire-in Light Control Controls interior or
exterior lights. wires into electrical socket
like a dimmer switch.
114A1321B
INSTALLATION AND OPERATION INSTRUCTIONS
ACCESSORIES
Model 753CB
Multi-Function Remote Control Controls
garage door openers and Light Control
Products.
Model 771CB
Screw-In Light Control Controls interior or
exterior lights Screws
into light socket.
Advertisement
