ADTRAN Total Access 300 Series Installation And Maintenance Manual page 21

NOTE
• Power supply input and output conductors of equipment, and signal
conductors of equipment which are exposed outside of the building, are
intended to be less that 140 feet (42.6 meters) and have adequate clearance
from power and lightning conductors in accordance with NEC 725 and 800.
Final acceptance of the Listed equipment installation will ultimately be up
to the local Authority Having Jurisdiction (AHJ).
• This product is designed to operate with a nominal operating voltage of 12
VDC.
This product is intended for deployment in Outside Plant Locations (for example, Customer
Premises). This product is to be installed and serviced by trained and qualified service
personnel only. Install this product in a restricted access location by trained service personnel
only in locations where the NEC applies (for example, Customer Premises).
This device is an FCC Class B device. This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause
Changes or modifications not expressly approved by ADTRAN could void the user's
authority to operate this equipment.
The equipment meets the EU's RoHS Directive 2002/95/EC and/or applicable exemptions.
Refer to
612877SBONT-5B
Section 1, Small Business Unit ONT - Safety and Regulatory Compliance
undesired operation.
www.adtran.com
for further information on RoHS/WEEE.
1-7