Select Cycle; Select Options; Start/Pause; When Cycle Ends - Whirlpool AWD712S2 User Manual And Online Warranty

3.4 Select cycle

Select the cycle based on the clothing loaded in the dryer.

3.5 Select options

Select the desired options.
The Quick option is available only for the Jeans, Towels and Normal cycles.
Quick option and Half Load option cannot be selected at the same time.

3.6 START/PAUSE

Press the
START/PAUSE
If the dryer does not start up, press the button on the back of the dryer to reset the
NOTE:
protection thermostat and press Start/Pause again. If the problem persists, check to see if the
ventilation system is obstructed or contact your service agent or qualified personnel.
Now the drum will begin to spin.
The drum will periodically stop and rotate in the other direction for a short period of time. This
will repeated throughout the entire drying cycle. It is important to take into account that the first
stop period may be longer than following ones.
If the clothing is dried before the cycle ends, or if an excessively long cycle time has been
selected, the built-in thermostat will automatically turn off the heater to prevent the clothing
from being over-drying and save energy, even though the drum will continue to rotate.
Simply open the door in the middle of a cycle to stop the machine; the drum will stop rotating
automatically.
Press the
START/PAUSE
There is an automatic 30-minute period at the end of each cycle which helps to smooth
out wrinkles. During this period, the dryer will make periodic rotations.

When cycle ends

3.7
Remove clothing as soon as the cycle has completed in order to reduce wrinkles.
NEVER UNPLUG THE DRYER AND LEAVE A WARM LOAD IN THE DRUM.
If any individual items are still damp after the drying cycle has completed, extend the drying
process by setting to a 30 minutes drying cycle. This will be required especially for
multi layered items such as pockets, collars etc.
II
button to start the cycle.
button again to restart the cycle.