Connecting Water Supply Hose - LG WT901CW Service Manual

2-2. CONNECTING WATER SUPPLY HOSE

Before connecting the water supply hose to the water tap, check the hose type, and then choose the
correct instruction here below.
Screw Type
1
Be sure there is a gasket in both ends of the hose.
Push the water supply hose up so that the rubber gasket
within the hose can adhere completely to the tap.
2
Connect the water supply hose to the tap.
Run a couple of gallons of water through the hoses into the drain or a
bucket to flush any particulate or contaminate.
3
Check water leakage.
After connecting the hose, open the tap to check for
any water leakage.
Connecting Water Supply Hose to the Machine
• Be sure there is a gasket in the end of the hose.
• Connect the hose to the appropriate inlet valve
(hot or cold) of the washing machine and tighten it
firmly.
• Turn on the water and check for leaks.
• Always install new hoses with a new washing
machine Do not re-use old hoses.
• Replace the hoses every five years.
• The hot and cold hoses are marked with a red or
NOTE :
blue stripe. Connect them to the appropriate taps.
• The hoses may appear the same, but they are not
physically identical. The hot hose has stronger walls,
a higher temperature rating, and a higher burst
strength. Do not reverse the hoses.
Gasket
6
Water tap
Rubber Seal
Water Supply Hose
Gasket