Read the weight reading in short time after loading. The output signature of load cell and A/D may be little influenced after weighing for a long time. Specifications Model TWH-01 Maximum capacity 300kg /600 lb Minimum weight 2 kg / 4 lb Scale division 0.1 kg / 0.2 lb...
2. UNPACKING AND INSTALLATION Take all scale parts out of the carton and put them on a flat and hard surface. Follow below procedures to fulfill the installation. 1. Place the cable (4) through the pillar (3). 2. Insert the pillar (3) into the tube support (6).
Page 5
8. Loose the screw on the upper bracket (8). 9. Locate the height rod (7) onto the fixing points (9) of the upper bracket (8) & lower bracket (12). 10. Secure the bolt and washer to the bracket on the base (10). 11.
4. OPERATIONS 4.1 Correct Weighing Press the start key ON/OFF/ZERO to enter the normal operating mode of the scale with no load on the platform. An automatic function test will be performed as well as the zero setting of the scale. When `0.0´ appears, it means you are in the weighing mode. Additionally the display shows the symbol ` ´...
when no weight on the platform or being switched off. 4.4 Weighing with preset tare values Press the ON/OFF/ZERO with no load on the scale. Press and hold the TARE/PRESET key until the NET indicator flashes and “ ”...
Press the BMI key shortly. The scale starts automatically with the last input. Use the arrow buttons to enter the height of the patient, and confirm the height with the enter button The BMI is now being displayed at the indicator. ...
5. TROUBLESHOOTING Display Probable causes Remedy Load cell wires to indicator are Make sure wires are ok and Ad﹉﹉﹉ incorrectly connected, or correctly connected. Replace shorted, or opened; or ADC, load load cell or ADC chip, Service Ad﹍﹍﹍ cell are damaged required.