Advertisement
Possible Causes
Problem
Lack of water.
"Add Water" indicator is on.
Water floater is stuck.
The ice basket is full.
"Ice Full" indicator is on.
Not connected to a power source.
No indicator lights up on
display.
The fuse blows.
Ice cubes are
Ice cubes are left in
water reservoir.
sticking together.
Room or water temperature in inner
tank is too high.
Refrigerant in cooling system
Ice making cycle is normal
is leaking.
but no ice is being formed.
Pipe in the cooling system is blocked.
Ice full sensor failed.
"Ice Full" indicator is not on
when the ice basket is full.
Infrared detection is affected by
strong light.
"ON/OFF" stays solid on and
Ice-making assembly is defrosting.
"CLEAN" flashes
Both "ON/OFF" and
Ice-making assembly is frozen.
"CLEAN" flash
14
Solution
Fill water up to the max level and press "On/Off" to restart.
If there is enough water in the reservoir, check if the water floater is
blocked. Clean and restart.
Remove the ice from the basket with scoop.
Be sure to connect to an appropriate electrical outlet.
Contact TaoTronics Support Team.
Stop the appliance, and restart it when the ice cubes melt.
Suggested room temperature:50°F - 90°F / 10°C - 32°C
Suggested water temperature: 40°F - 82°F / 4°C - 28°C
Contact TaoTronics Support Team.
Contact TaoTronics Support Team.
Move the ice maker to relatively dark place.
Wait 30 minutes for the ice maker to return to normal. Or you can press
and hold the "CLEAN" Button to start cleaning, then press "ON/OFF" to
restart after cleaning is done.
Wait 20 minutes for the ice maker to defrost automatically. If
problem persists, contact TaoTronics Support Team.
The following troubleshooting
guide addresses the most
common problems. If problems
persist, feel free to contact the
TROUBLESHOOTING
Customer Support at
support@taotronics.com
6
GUIDE
15
Hide quick links:
Advertisement
