Black Max BM26BV Engine Starting Procedure

WARNING:
This Engine Starting Procedure is not a substitute for reading
the operator's manual. To reduce the risk of injury, user must read and understand
operator's manual before using this product.
TO START:
50:1 Ratio = Mix 2.6 oz 2-cycle oil with
1 gallon of fresh gasoline in separate gas
2.6
oz.
1 GALLON
container. SHAKE. Pour into fuel tank.
GAS
Slowly press the PRIMER BULB 10x or until fuel appears.
SET choke lever to FULL choke.
Lock throttle/cruise control lever.
Pull starter grip and rope until engine attempts
to start (4X max.)
SET choke lever to HALF choke.
Pull starter grip and rope until engine starts (6X max.)
NOTE: If the unit has not started, return to step 3.
Allow the engine to warm for 10 seconds,
SET choke lever to RUN.
TO STOP:
PRESS and HOLD stop switch until
engine stops.
TO RESTART A HOT ENGINE:
SET choke lever to RUN.
Lock throttle/cruise control lever.
Pull starter grip and rope until engine starts.
ENGINE STARTING PROCEDURE
Make The Most Of Your Purchase!
Go to www.blackmaxtools.com and register your new tool on-line.
For any questions about operating or maintaining your product, call the
BLACK MAX Help Line! Your product has been fully tested prior to shipment to ensure
your complete satisfaction.Troubleshooting tips are available in your operator's manual.
NOTICE: Do not use E15 or E85 fuel in this
product. It is a violation of federal law and
will damage the unit and void your warran-
ty. Only use unleaded gasoline containing
up to 10% ethanol.
995000933
6-20-19 (REV:01)