Displays And Buttons - Citizen FS16 Manual

2. Separated Parts
Setting stem
Length from movement
center to far end of
setting stem
Thread
3. Others
* Measurement of time rate
The unit(gate) time of measurement must be set at "10 sec." or integer fold
value of 10 sec. owing to the DFC system, and the measurement must be
performed in the form of complete watch.
* Marking on movement
* Typical clearance
Mov't - Casebaminimum 200 microns
Top of hands -300 - 400 microns *
* subject to the glass, case structure, and the length of hand
* Note
Please use aluminum material hand for Chrono second hand
* TACHYMETER
The tachymeter is the device which measures the speed of an automobile. Knowing is how many seconds the car
covers a distance of 1km, the meter can measure the approximate average speed per hour during a jorney ( up to
the maxinum measurable range of tachymeter is 60 seconds.)
If the chronograph is started at the same time as measurement, and stopped after 1 km, the average speed per hour
can be determined according to the position of the second hand. If the car covers the distance of 1km in 45 seconds,
the average hourly speed during the journey will be about 80 km.
4. Instruction Manual

【Displays and Buttons】

Hour Hand
(local time)
Chronograph
Minutes Hand
12 Hour Hand
(home time)
Small Second Hand
065- 549
20.00mm
Ф0.9mm×9.06mm
JAPAN
MIYOTA CO.
( CAL. NO.)
NO JEWELS
Calendar
(local time)
×1
Chronograph
Second Hand
PB 1
24 Hour Hand
(home time)
2st Click Position
PB 2
1st Click Position
Normal Position