Self Launching - Cabrinha CO2 Manual

KB BASICS

SELF LAUNCHING

• First set your kite face down, with the leading edge into the wind, at 100 to 110
degrees off of the wind.
• Secure the kite with sand or with sandbags.
• Next, wind your lines out from the kite to the place from where you will launch the
kite.
• Check to make sure your lines are connected properly.
• Once you have thoroughly checked your lines, your gear, and your launching and land-
ing sites, you are ready to set your kite up for self-launch. Turn the kite on its side,
with the leading edge facing into the wind.
• Fold the bottom wing tip (the one closest to the ground) over onto the kite. Make the
fold at the first strut..
• Weigh this wing tip down heavily with sand or sand bags.
• Make sure that the flying lines and bridle (if applicable) are free and will not catch on
the struts when you self-launch.
• Quickly walk back to your bar.
SELF LAUNCHING
CONT'