Advertisement
Quick Links
www.nationwideindustries.com
NATIONWIDE
Keystone® Advantage
INOUSTIWES
KLADV-P2
(for 1-3/4" to 5" POST) &
KLADV-M2
(for 2" to 5" POST)
INSTALLATION, ADJUSTMENT AND MAINTENANCE INSTRUCTIONS
REV. (J) 12-13-17
PLEASE CAREFULLY READ ALL OF THE
INSTRUCTIONS PRIOR TO INSTALLATION
STEP-1
Use one of the following methods for locating the mounting holes required
to install the latch. THESE INSTRUCTIONS APPLY TO ALL POST SIZES.
WITHOUT MOUNTING TEMPLATE
At the desired mounting height of the Keystone®Advantage on the Fence Post, mark the centerpoints
of the 2 holes, 5/8" from post edge spaced by 2-11/16". Drill 5/8" diameter holes at both centerpoints (fig 1).
IMPORTANT: HOLES MUST BE STRAIGHT AND LEVEL.
WITH MOUNTING TEMPLATE
Draw a level line at the desired height for the latch on the side of
the post facing the gate. This line will locate the center of the latch
when installed (fig 2).
Next, align the template so that the side with (3) holes is on the
side of the post with the line. The line should be visible through the
center hole of the template (fig 3). Mark all (7) holes provided in the
template.
Reverse the template (fig 4) and align as described in previous
step. Mark all holes in template.
Using marks created in previous steps, drill all (14) mounting holes.
The two center spindle holes (fig 5) require a 05/8" hole. All other
holes will be drilled to 01/8".
05/8"
Fig.#1
2 11/16"
STEP-2
The Keystone® Advantage is designed to fit
both right-hand and left-hand applications.
To conform to your application both the button
assembly (fig 6) and the latch assembly (fig 7)
may need to be reversed. To reverse the button
assembly: remove the four screws holding in the
mounting base, carefully lift and rotate the mounting
base. To reverse the latch assembly: remove the
four screws holding the mounting base, carefully
lift and rotate the mounting base.
IMPORTANT: INNER COMPONENTS MUST NOT
BE DISTURBED WHILE REVERSING THE ASSEMBLIES.
Remove
Screws
Fig.#6
Remove
Screws
STEP-3
Pick fence post size from chart below. Keystone ® Advantage
is designed to fit many poet sizes. IMPORTANT: BE
CAREFUL TO AVOID BENDING SPINDLE DURING
CUTTING PROCESS
Post Size
Cut Location on Spindles
1-3/4 X 3 1/2
("P2" Type ONLY)
Cut at the Seventh Inscribed Cut Mark
2 X 2
Cut at the Sixth Inscribed Cut Mark
2 X
3112
Cut at the Sixth Inscribed Cut Mark
3 X 3
Cut at the Fourth Inscribed Cut Mark
3112 Xi 1/2
Cut at the Third Inscribed Cut Mark
4 X 4
Cut at the Second Inscribed Cut Mark
5 X 5
DO NOT CUT SPINDLE
3 1/4"
Seventh Cut Mark
Sixth Cut Mark
Fourth Cut Mark
Third Cut Mark
Second Cut Mark
1112"
2
1 OF 2
Advertisement
