Toro 51594 Operator's Manual page 5

Starting/Stopping/Adjusting the Air Speed
Using the Concentrator Nozzle Accessory
Install the concentrator nozzle into the blower tube to help reach into
narrow spaces or to remove matted debris from hard surfaces.
Remove the concentrator nozzle when finished.
Using the Blower
The blower is intended for residential use only. Use the blower
outdoors to move debris as needed.
WARNING
The blower can throw debris, possibly causing serious personal
injury to the operator or bystanders.
•
Do not blow hard objects such as nails, bolts, or rocks.
•
Do not operate the blower near bystanders or pets.
•
Use extra care when cleaning debris from stairs or other tight
areas.
•
Wear safety goggles or other suitable eye protection, long
pants, and shoes.
Using the Vacuum
WARNING
The vacuum can throw debris, possibly causing serious personal
injury to the operator or bystanders.
•
Do not operate the vacuum without the bag installed or with
the bag zipper open.
•
Do not vacuum sharp, pointed, or hard objects that could be
thrown through the fabric of the bag, such as wires, staples,
nails, or rocks.
NOTICE! Vacuum only leaves and soft items. Hard items such as
sticks, rocks, acorns, and pine cones will damage the impeller.
NOTICE! Do not force the vacuum tube into a pile of debris or
hold the tube upright while force feeding debris into the tube.
Either action may clog and damage the impeller. If the vacuum
starts to vibrate or make abnormal noise, stop it, unplug the cord,
and check for the cause.
Emptying the Bag
1. Turn off and unplug the vacuum from the power source.
2. Empty any debris from the bag.
Do not store debris in the bag. To clean the bag, turn it inside out
and shake out any excess debris. Once a year, hand wash the
bag in soapy water and allow it to air dry.
DANGER
Normal usage of the bag causes it to wear and deteriorate
over time. A worn or deteriorated bag allows small objects to
be thrown through the bag, possibly injuring the operator
or bystanders.
Check the bag frequently. If it is worn or deteriorated, replace
it with a genuine Toro vacuum bag.
Removing Clogged Debris from the
Impeller
1. Turn off and unplug the vacuum from the power source and wait
for all moving parts to stop.
5