Craftsman CMXGZBF7124441 Instruction Manual page 11

Step 6: (fig. 24)
1. Assemble ball end of control cable up through hole in
cable end fitting and pull until ball slips insided curled
edge of fitting. If ball won't slip under edge of curl, it
will need to be inserted through open end of curl.
2. Assemble 1/4" x 1-1/2" hex bolt (B) down through the
cable end fitting, the 5/8" lonog spacer (T) and the
left hand hole in the channel assembly. Secure with a
1/4" nylock nut (K). Tighten.
nOTE: Make sure the calbe mount bracket is aligned with
the cable end fitting to prevent binding of cable. The other
end of the control cable will be attached in a later step.
Fig. 24
CABLE END
FITTING (1)
1/4" NYLOCK NUT (K)
1/4" x 1-1/2"
HEX BOLT (B)
5/8" SPACER (T)
CHANNEL
ASSEMBLY
HOLE
REAR
Step 7: (fig. 25)
1. To attach the blade to the channel assembly, align the
notched holes in the pivot plate with the notched
holes in the blade, Insert a 1/8" x 1-1/4" cotter pin (V)
down through the hole at the bend in the blade pivot
shaft. Spread the ends of the pin. From the left side
insert the blade pivot shaft, bend facing top of blade,
through the notched holes. Secure the shaft with
another 1/8" x 1-1/4" cotter pin (V) through the end
hole in the shaft. Spread the ends of the pin.
2. Remove the plastic cap and one 3/8" hex nut from the
bolt in the blade adjust spring. Adjust the remaining
3/8" hex nut down approximately 1" onto the bolt
threads. Hook the spring over the spring mount rod.
Place the bolt up through the hole in the top edge
of the blade and reassemble the other 3/8" hex nut
to the bolt and tighten down against the top edge of
the blade. Replace the plastic cap over the end of the
bolt threads.
Fig. 25
1/8" x 1-1/4"
COTTER PIN (V)
BLADE
PIVOT
SHAFT (11)
SPRING
PIVOT PLATE
MOUNT
ROD
NOTCHED HOLE
EnglIsh
PLASTIC
CAP
3/8" HEX NUT
(TOP)
3/8" HEX NUT
(BOTTOM)
BLADE
BLADE
ADJUST
SPRING
1/8" x 1-1/4"
COTTER PIN (V)
9