Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Kettler Kalos KLEH150-0500
Summary of Contents for Kettler Kalos KLEH150-0500
- Page 1 Assembly Instructions Headline Terrace Floor Standing Electric Heater KLEH150-0500 IMPORTANT PLEASE KEEP THIS BOOKLET FOR FUTURE REFERENCE. THIS IS IMPORTANT INFORMATION REGARDING THE USE AND CARE OF YOUR HALOGEN HEATER. ASSEMBLY PERSONS TIME REQUIRED Sept 2020...
- Page 2 Do not use any other tools other than those recommended to build this product. Please do not use substitute parts. Use only additional or replacement parts supplied by Kettler. In the unlikely event that this product has missing or damaged parts, please visit our website...
-
Page 3: For Your Safety
For Your Safety Warning Caution • This heater is not equipped with a • Some parts of this product can become device to control the room temperature. very hot and cause burns. Particular DO NOT use this heater in small rooms attention has to be given where children when they are occupied by persons and vulnerable people are present. - Page 4 For Your Safety 12. The unit must be placed with the DON’T use this unit as a cloth drier clearance of 100cm to the wall. or towel drier. 13. The unit must be correctly installed DON’T use this unit as a sauna heater. according to the instructions.
-
Page 5: Installation
Installation WARNING! These appliances must be earthed. Before installing or replacing the bulb, the appliance must be always being disconnected from the 220-240V supply. Terrace Floor Standing Heater is built with the best quality components in accordance to the prevailing legal regulations and certified for safety in use. For best results from the appliance please ensure that the installation is done by a qualified electrician in accordance with the following instructions and taking full account of current regulations. - Page 6 Assembly • Step 1: • Step 2: Fix the Pull the bottom power tube cord onto the through base by the pole screwing. and base. • Step 3: Place the power cable throght middle tube, and Tighten up the tubes.
- Page 7 • Step 4: Place the power cable throght the top tube,and tighten up.
- Page 8 Assembly • Step 5: Connect the power cord plug to the socket in the heater head. • Step 6: Connect the heater head with the tube by screwing them together.
- Page 9 Assembly • Step 7: Fixed the power cord with the press clip in the base. • Step 8: Fix the heater on the floor. Bore three holes in the floor, fix the heater by three wedge bolts on the floor tightening the screws by spanner.
-
Page 10: Remote Control
Operating Instructions Connect the power cable to a 220-240V, 13 amp supply that is located in a safe, dry area. Press the button ,the heater will be ready mode. • Touch the touch switch once, the heater will be on 800W. •... -
Page 11: Troubleshooting
Operating Instructions Trouble Shooting Technical specification • Power supply 220-240V, 50-60Hz If the heater will not operate, please check the following before seeking repair of service: • Wattage max 2000W • Check if the power cord is plugged into an •... - Page 12 This warranty applies to domestic use only. It does not cover commercial use, mis-use or accidental damage. To validate your warranty, register at www.kettler.co.uk and quote www.kettler.co.uk the product code from the front of this booklet.